Do not over tighten nuts! Tighten only until firmly snug. This is especially important when working with plastic skis. They always have a cushioned feel to them, unlike steel skis which provide a dead stop to the nut. We use 5/16" x 18 bolts because these are all that is necessary - strength-wise. Having more than one bolt only helps keep the host bar straight. Also, this allows the easiest installation without any need to drill the skis or use a hammer. It is not the size of the bolts, but the number and location that is important. Easy installation To prevent cross-threading, rotate the nut counter-clockwise until you feel the end of the nut's thread fall over the end thread of the bolt. Then, turn clockwise to tighten. Front 90 degree bend - Not! Easy installation Product enhancements
To specify Triple Point Carbide models, replace the Good 'n Ugly prefix C or CH with TP For example: C-B13 becomes TP-B13 or CH6-B12 becomes TP6-B12
Model numbers shown below are for Good n Ugly single carbides only.
Front 90 degree bend - Not! Easy installation Product enhancements Home
|
Ski-doo Wear Rod Drawings | Ski Savers Chart
| Trail Grabbers Chart Copyright © 1999-2010 Bergstrom Skegs, Inc. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||